RE: [CAD_CAM_EDM_DRO] Re: motor cables connection
Posted by
John Guenther
on 2003-08-06 07:38:26 UTC
I use 5 pin DIN connectors which I purchase from Jameco. These work well
for my system, 70 volts at < 2 amps but YMMV. I also use 6 foot keyboard
extension cables to wire up my motors, no problems to date. I would however
like to find some really flexible 18 or 20 gauge 4 conductor cable that does
not cost a fortune. I can't tell from the catalogs how flexible the cable
that is available is so any feedback anyone here can provide would be
appreciated.
John Guenther
'Ye Olde Pen Maker'
Sterling, Virginia
for my system, 70 volts at < 2 amps but YMMV. I also use 6 foot keyboard
extension cables to wire up my motors, no problems to date. I would however
like to find some really flexible 18 or 20 gauge 4 conductor cable that does
not cost a fortune. I can't tell from the catalogs how flexible the cable
that is available is so any feedback anyone here can provide would be
appreciated.
John Guenther
'Ye Olde Pen Maker'
Sterling, Virginia
Discussion Thread
terracnc
2003-08-05 22:17:21 UTC
motor cables connection
turbulatordude
2003-08-06 07:23:25 UTC
Re: motor cables connection
John Guenther
2003-08-06 07:38:26 UTC
RE: [CAD_CAM_EDM_DRO] Re: motor cables connection
Don Rogers
2003-08-06 20:23:36 UTC
Re: motor cables connection
notoneleft
2003-08-07 09:28:20 UTC
Re: motor cables connection
JanRwl@A...
2003-08-07 12:34:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: motor cables connection
Tim Goldstein
2003-08-07 13:05:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: motor cables connection
JanRwl@A...
2003-08-07 13:47:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: motor cables connection