Re: motor cables connection
Posted by
notoneleft
on 2003-08-07 09:28:20 UTC
The Pacific Scientific installation bulletin shows 22 awg wire on
Nema 23 motors. Where do they recommend 16 awg? Or are you using
larger motors? Thanks
Gerry
Nema 23 motors. Where do they recommend 16 awg? Or are you using
larger motors? Thanks
Gerry
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Don Rogers <Don@C...> wrote:
> At 03:59 PM 8/6/03 +0000, you wrote:
> >I would however
> >like to find some really flexible 18 or 20 gauge 4 conductor cable
that does
> >not cost a fortune.
>
> I am in the process of doing a CNC Retrofit on my Taig. I'm using
Pacific
> Scientific motors and they recommend 16ga shielded wire. I did
find some
> at a local electronics supply. It is rubber covered so it is very
> flexible. The big problem is going to be splitting the wires to
fit the
> socket on the motor. Not impossible, but a lot of soldering and
heat
> shrink to get a finished job. Seems that the wire was about $1.75
a ft.
>
> While I was looking at different distributors, I came on the idea
of using
> speaker wire. You can get a four wire flat configuration speaker
wire in
> heavy gage that isn't too expensive and it has the flexibility of a
piece
> of over cooked spaghetti. The four wide wire was kind of like a
ribbon
> cable on steroids. What steered me away was the shielding issue.
I could
> have bought braid and covered the wire, but the finished product
was going
> to be around $5.00 a ft, mainly due to the cost of the braid. If
you don't
> want or need the shielding, it would be an inexpensive way to go.
I
> wouldn't go to an audio store, but to an electronic supply store
for a
> better price.
>
> Don
Discussion Thread
terracnc
2003-08-05 22:17:21 UTC
motor cables connection
turbulatordude
2003-08-06 07:23:25 UTC
Re: motor cables connection
John Guenther
2003-08-06 07:38:26 UTC
RE: [CAD_CAM_EDM_DRO] Re: motor cables connection
Don Rogers
2003-08-06 20:23:36 UTC
Re: motor cables connection
notoneleft
2003-08-07 09:28:20 UTC
Re: motor cables connection
JanRwl@A...
2003-08-07 12:34:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: motor cables connection
Tim Goldstein
2003-08-07 13:05:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: motor cables connection
JanRwl@A...
2003-08-07 13:47:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: motor cables connection