Re: Gecko 340 drives and tuning
Posted by
wjh45dakota
on 2003-08-23 23:18:59 UTC
In addition to the previous replies. A servo not tuned properly
will have poor performance. Lacking power and speed. I experienced
this with my mill faulting out while drilling holes. The G320 drive
was not tuned properly. After tuning, it punches holes though most
anything now.
Wayne
will have poor performance. Lacking power and speed. I experienced
this with my mill faulting out while drilling holes. The G320 drive
was not tuned properly. After tuning, it punches holes though most
anything now.
Wayne
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "tig415" <tig416@e...> wrote:
>
>
> If a gecko 340 is not tuned properly ( gain and dampening) will it
> loose steps without faulting?
>
> Thanks
> Derek
Discussion Thread
tig415
2003-08-22 07:40:04 UTC
Gecko 340 drives and tuning
Tim Goldstein
2003-08-22 07:48:57 UTC
RE: [CAD_CAM_EDM_DRO] Gecko 340 drives and tuning
Jon Elson
2003-08-22 10:05:20 UTC
Re: [CAD_CAM_EDM_DRO] Gecko 340 drives and tuning
wjh45dakota
2003-08-23 23:18:59 UTC
Re: Gecko 340 drives and tuning