One dump encoder pulse question more...
Posted by
Mika Salmi
on 2003-08-30 07:15:08 UTC
Hi, to all
I just tested pair of new encoders I got cheaply.
The encoders are made in Taiwan by Hontko Co. Type is: HTR-HB-8-1024-3-L.
Spec says they are 5V, 1024 pulses per rev, with line driver cirquit.
When I hook them up top my new oscilloscope I got nice differential pulses whitout problem but the edge of pulse is only 3,3V which maybe is too low for my Rutex drives.
Does enyone know if I can make similar pull up with 5v and resistor as step and dir pulse line sometimes need?
Thanks in advance,
Regards Mika.
[Non-text portions of this message have been removed]
I just tested pair of new encoders I got cheaply.
The encoders are made in Taiwan by Hontko Co. Type is: HTR-HB-8-1024-3-L.
Spec says they are 5V, 1024 pulses per rev, with line driver cirquit.
When I hook them up top my new oscilloscope I got nice differential pulses whitout problem but the edge of pulse is only 3,3V which maybe is too low for my Rutex drives.
Does enyone know if I can make similar pull up with 5v and resistor as step and dir pulse line sometimes need?
Thanks in advance,
Regards Mika.
[Non-text portions of this message have been removed]
Discussion Thread
Mika Salmi
2003-08-30 07:15:08 UTC
One dump encoder pulse question more...
Harvey White
2003-08-30 09:00:43 UTC
Re: [CAD_CAM_EDM_DRO] One dump encoder pulse question more...
JanRwl@A...
2003-08-30 15:39:14 UTC
Re: [CAD_CAM_EDM_DRO] One dump encoder pulse question more...
James Cullins
2003-08-30 17:35:07 UTC
Re: [CAD_CAM_EDM_DRO] One dump encoder pulse question more...
Jon Elson
2003-09-01 21:46:02 UTC
Re: [CAD_CAM_EDM_DRO] One dump encoder pulse question more...
Mika Salmi
2003-09-05 11:48:06 UTC
Re: [CAD_CAM_EDM_DRO] One dump encoder pulse question more...