Problems, cnc/electronic idiot
Posted by
kadeshan
on 2003-09-28 20:36:31 UTC
I am having problems getting my cnc system running properly. I have
gecko 320's and power supply kit from camtronics. Just finished it
up today, and can't get it to function properly. Power supply checks
out fine. On the db25 breakout board what do I need connected besids
step and direction from each axis? Do I need to run a 5v from my pc
power supply to this, what about a ground? Looking at the wiring
diagram, all that goes to the break out board is the step/dir from
the drives. I tried it with just the step direction, and the servo
motors engage, but they aren't getting any signal, anybody got any
ideas where I should start? Thanks
gecko 320's and power supply kit from camtronics. Just finished it
up today, and can't get it to function properly. Power supply checks
out fine. On the db25 breakout board what do I need connected besids
step and direction from each axis? Do I need to run a 5v from my pc
power supply to this, what about a ground? Looking at the wiring
diagram, all that goes to the break out board is the step/dir from
the drives. I tried it with just the step direction, and the servo
motors engage, but they aren't getting any signal, anybody got any
ideas where I should start? Thanks
Discussion Thread
kadeshan
2003-09-28 20:36:31 UTC
Problems, cnc/electronic idiot
Tim Goldstein
2003-09-28 20:49:49 UTC
RE: [CAD_CAM_EDM_DRO] Problems, cnc/electronic idiot
kadeshan
2003-09-28 20:58:17 UTC
Re: Problems, cnc/electronic idiot
Tim Goldstein
2003-09-28 21:11:47 UTC
RE: [CAD_CAM_EDM_DRO] Re: Problems, cnc/electronic idiot
kadeshan
2003-09-29 21:46:35 UTC
Re: Problems, cnc/electronic idiot...More DUMB questions
Jon Elson
2003-09-30 10:00:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: Problems, cnc/electronic idiot...More DUMB questions