Servo Dynamics 1525 servo drive noise
Posted by
shawncd2001
on 2003-10-07 05:51:12 UTC
I recently purchased an older Milltronics Partner mill. This
particular unit uses the older Servo Dynamics 1525 servo drives.
I have tuned the drives to where they perform the way I want them,
but there is an ear piercing whine or whistling sonund coming from
the boards. Anybody out there have the same problem? Any ideas on a
fix? Any information would be much appreciated.
particular unit uses the older Servo Dynamics 1525 servo drives.
I have tuned the drives to where they perform the way I want them,
but there is an ear piercing whine or whistling sonund coming from
the boards. Anybody out there have the same problem? Any ideas on a
fix? Any information would be much appreciated.
Discussion Thread
shawncd2001
2003-10-07 05:51:12 UTC
Servo Dynamics 1525 servo drive noise
doug98105
2003-10-07 06:23:58 UTC
Re: Servo Dynamics 1525 servo drive noise
Bob Simon
2003-10-07 06:54:28 UTC
Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise
Jon Elson
2003-10-07 09:39:08 UTC
Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise
k8zre
2003-10-07 10:55:12 UTC
Re: Servo Dynamics 1525 servo drive noise
Shawncd
2003-10-07 18:14:52 UTC
Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise
Jon Elson
2003-10-07 22:56:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo Dynamics 1525 servo drive noise
Jon Elson
2003-10-07 23:10:46 UTC
Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise
dan
2003-10-08 09:58:56 UTC
Low cost Servo drives +/-10V analog....and Camsoft.
Shawncd
2003-10-08 18:30:09 UTC
Re: [CAD_CAM_EDM_DRO] Low cost Servo drives +/-10V analog....and Camsoft.
Shawncd
2003-10-08 19:01:03 UTC
Re: [CAD_CAM_EDM_DRO] Low cost Servo drives +/-10V analog....and Camsoft.
Jon Elson
2003-10-15 09:45:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo Dynamics 1525 servo drive noise
k8zre
2003-10-15 16:55:10 UTC
Re: Servo Dynamics 1525 servo drive noise