CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise

Posted by Bob Simon
on 2003-10-07 06:54:28 UTC
At 12:51 PM 10/7/03 +0000, you wrote:
>I recently purchased an older Milltronics Partner mill. This
>particular unit uses the older Servo Dynamics 1525 servo drives.
>I have tuned the drives to where they perform the way I want them,
>but there is an ear piercing whine or whistling sonund coming from
>the boards.

The older SD and Westamp drives have a low switching frequency of around
5khz. This is in the human audio hearing range. Newer amps switch at 16 khz
or better and are virtually silent.

-Bob

Discussion Thread

shawncd2001 2003-10-07 05:51:12 UTC Servo Dynamics 1525 servo drive noise doug98105 2003-10-07 06:23:58 UTC Re: Servo Dynamics 1525 servo drive noise Bob Simon 2003-10-07 06:54:28 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise Jon Elson 2003-10-07 09:39:08 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise k8zre 2003-10-07 10:55:12 UTC Re: Servo Dynamics 1525 servo drive noise Shawncd 2003-10-07 18:14:52 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise Jon Elson 2003-10-07 22:56:57 UTC Re: [CAD_CAM_EDM_DRO] Re: Servo Dynamics 1525 servo drive noise Jon Elson 2003-10-07 23:10:46 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise dan 2003-10-08 09:58:56 UTC Low cost Servo drives +/-10V analog....and Camsoft. Shawncd 2003-10-08 18:30:09 UTC Re: [CAD_CAM_EDM_DRO] Low cost Servo drives +/-10V analog....and Camsoft. Shawncd 2003-10-08 19:01:03 UTC Re: [CAD_CAM_EDM_DRO] Low cost Servo drives +/-10V analog....and Camsoft. Jon Elson 2003-10-15 09:45:25 UTC Re: [CAD_CAM_EDM_DRO] Re: Servo Dynamics 1525 servo drive noise k8zre 2003-10-15 16:55:10 UTC Re: Servo Dynamics 1525 servo drive noise