CAD CAM EDM DRO - Yahoo Group Archive

Re: Servo Dynamics 1525 servo drive noise

Posted by doug98105
on 2003-10-07 06:23:58 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "shawncd2001" <shawncd@p...>
wrote:
> I recently purchased an older Milltronics Partner mill. This
> particular unit uses the older Servo Dynamics 1525 servo drives.
> I have tuned the drives to where they perform the way I want them,
> but there is an ear piercing whine or whistling sonund coming from
> the boards. Anybody out there have the same problem? Any ideas on
a
> fix? Any information would be much appreciated.

I suggest you call Servo Dynamics and ask them for an opinion. I
have several machines with SD drives and have found their support to
be helpful.

One of my machines use the 1525 drives, they're quiet.

Doug

Discussion Thread

shawncd2001 2003-10-07 05:51:12 UTC Servo Dynamics 1525 servo drive noise doug98105 2003-10-07 06:23:58 UTC Re: Servo Dynamics 1525 servo drive noise Bob Simon 2003-10-07 06:54:28 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise Jon Elson 2003-10-07 09:39:08 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise k8zre 2003-10-07 10:55:12 UTC Re: Servo Dynamics 1525 servo drive noise Shawncd 2003-10-07 18:14:52 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise Jon Elson 2003-10-07 22:56:57 UTC Re: [CAD_CAM_EDM_DRO] Re: Servo Dynamics 1525 servo drive noise Jon Elson 2003-10-07 23:10:46 UTC Re: [CAD_CAM_EDM_DRO] Servo Dynamics 1525 servo drive noise dan 2003-10-08 09:58:56 UTC Low cost Servo drives +/-10V analog....and Camsoft. Shawncd 2003-10-08 18:30:09 UTC Re: [CAD_CAM_EDM_DRO] Low cost Servo drives +/-10V analog....and Camsoft. Shawncd 2003-10-08 19:01:03 UTC Re: [CAD_CAM_EDM_DRO] Low cost Servo drives +/-10V analog....and Camsoft. Jon Elson 2003-10-15 09:45:25 UTC Re: [CAD_CAM_EDM_DRO] Re: Servo Dynamics 1525 servo drive noise k8zre 2003-10-15 16:55:10 UTC Re: Servo Dynamics 1525 servo drive noise