Re: [CAD_CAM_EDM_DRO] Re: Cheap drivers - special offer from Phytron.de

The drive is the ZMX model. The offer is on their home page
http://www.phytron.de/

The data sheet is here
http://www.phytron.de/home/pdf/zmx03-1d.pdf
Unfortunately all the details are in German but you can piece together the
information you need. They are up to 20 microstep, 0.75 to 9A at 80V max.
They are standard step+direction drivers so they will work fine with
TurboCNC.

Phytron are not geared up to private sales to you have to send them a cheque
or do a bank transfer. Either way they only accept Euros. I am in the
process of trying to buy three so hopefully I will be able to tell you what
they are like in the near future.

Les

----- Original Message -----
From: "ajv2803959" <antonio_ximenez@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, November 13, 2003 12:08 PM
Subject: [CAD_CAM_EDM_DRO] Re: Cheap drivers - special offer from Phytron.de


Hi, I don´t see the offer announce in the web, so I have been
navigating in phytron web and I have question

Is the model in offer GCD 93-70 ?
Is it possible to use this model with step and direction signal ?
Can I use TurboCnC with this drivers ?

If I can use only serial port what software is suitable for control.
Support for Gcodes.


Thanks in advance