Re: Cheap drivers - special offer from Phytron.de

Les, you are a kindy man. I am going to make an order, I am from Spain
euro zone so I think I would not have any problem.

Thanks a lot of


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Les Newell" <lesnewell@f...>
wrote:

> The drive is the ZMX model. The offer is on their home page
> http://www.phytron.de/
>
> The data sheet is here
> http://www.phytron.de/home/pdf/zmx03-1d.pdf
> Unfortunately all the details are in German but you can piece

together the

> information you need. They are up to 20 microstep, 0.75 to 9A at 80V

max.

> They are standard step+direction drivers so they will work fine with
> TurboCNC.
>
> Phytron are not geared up to private sales to you have to send them

a cheque

> or do a bank transfer. Either way they only accept Euros. I am in

the

> process of trying to buy three so hopefully I will be able to tell

you what

> they are like in the near future.
>
> Les
>
> ----- Original Message -----
> From: "ajv2803959" <antonio_ximenez@h...>
> To: <CAD_CAM_EDM_DRO@yahoogroups.com>
> Sent: Thursday, November 13, 2003 12:08 PM
> Subject: [CAD_CAM_EDM_DRO] Re: Cheap drivers - special offer from

Phytron.de

>
>
> Hi, I don´t see the offer announce in the web, so I have been
> navigating in phytron web and I have question
>
> Is the model in offer GCD 93-70 ?
> Is it possible to use this model with step and direction signal ?
> Can I use TurboCnC with this drivers ?
>
> If I can use only serial port what software is suitable for control.
> Support for Gcodes.
>
>
> Thanks in advance