Re: [SherlineCNC] Reflective pickup
Posted by
Bryan Mumford
on 2003-11-28 19:59:58 UTC
At 1:39 AM -0500 11-28-03, wanliker@... wrote:
part they use is available from DigiKey as QRD1114 at 94 cents each.
Sherline even has a molded holder for it to screw it to the pulley
guard, and I'll bet you can buy the whole assembly as a spare part.
But you will need to provide it with 5 volts and "pull up" the output.
I prefer to use a Hall effect (magnetic) sensor. I make a timing tool
that can also be used as a Sherline tachometer. You can see pictures
here:
http://www.bmumford.com/mset/tech/tach/index.html
--
Bryan Mumford
Santa Barbara, California
http://www.bmumford.com
>Can anyone on the list give me a suggested part numbet to add a pickAs you may know, Sherline uses a reflective sensor for their DRO. The
>up on a Sherline lathe for TurboCNC threading.
part they use is available from DigiKey as QRD1114 at 94 cents each.
Sherline even has a molded holder for it to screw it to the pulley
guard, and I'll bet you can buy the whole assembly as a spare part.
But you will need to provide it with 5 volts and "pull up" the output.
I prefer to use a Hall effect (magnetic) sensor. I make a timing tool
that can also be used as a Sherline tachometer. You can see pictures
here:
http://www.bmumford.com/mset/tech/tach/index.html
--
Bryan Mumford
Santa Barbara, California
http://www.bmumford.com
Discussion Thread
wanliker@a...
2003-11-27 22:39:22 UTC
Reflective pickup
Peter Homann
2003-11-27 22:59:49 UTC
RE: [CAD_CAM_EDM_DRO] Reflective pickup
Kim Lux
2003-11-28 06:32:54 UTC
Re: [CAD_CAM_EDM_DRO] Reflective pickup
Vince Negrete
2003-11-28 06:47:29 UTC
Re: [CAD_CAM_EDM_DRO] Reflective pickup
ccq@x...
2003-11-28 09:01:03 UTC
Re: [CAD_CAM_EDM_DRO] Reflective pickup
Bryan Mumford
2003-11-28 19:59:58 UTC
Re: [SherlineCNC] Reflective pickup
bsjoelund
2003-11-29 00:30:46 UTC
Re: Reflective pickup
James Cullins
2003-12-01 06:31:26 UTC
Re: [CAD_CAM_EDM_DRO] Reflective pickup