Re: Power supply schematic???

Thanks Rich. I found a few schematics online and searched through
the files and archives on here but couldn't find a schematic which
used comparable components which I have. I'm lost when it comes to
knowing which resistors to use etc. since I'm a pilot by trade and
just learning about all of this stuff. Thanks for your help.

Frank

--- In CAD_CAM_EDM_DRO@yahoogroups.com, RichD <cmsteam@s...> wrote:
> Frank,
> Look at this site for a very typical power supply diagram.
> AC Line > Xformer > bridge rectifier > capacitor > circuit of
choice.
>
> http://braincambre500.freeservers.com/adjustable%20power%
20supply.htm
>
> This was found instantly by a search for "power supply schematic"
> on Google.com.
> RichD
>
> fun2b432002 wrote:
> >
> > Does anyone have a schematic for a 48V power supply? I'm
building
> > my CNC controller using 3 world servo SST1500 amps and the manual
> > calls for unregulated DC voltage from 24 to 75 volts. A bulk
linear
> > supply (Transformer, bridge rectifier, and capacitor). The
> > gentleman I bought the amps from suggested using the following
> > components which I have:
> >
> > Hammond toroidal power LV rectifier, 117/234, 750VA, 48VCT@1...
> > (24V@3...)
> >
> > Bridge rectifier, single phase, 25A, 600V
> >
> > Two 15,000 uF 100VDC capacitors
> >
> > If anyone has a schematic or could design me a schematic for a
fee I
> > would greatly appreciate it. Thanks.
> >
> > Frank
> >