Re: loking for help with power supply for rutex drives...
Posted by
ckhaun2000
on 2003-12-11 17:11:02 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Dave Fisher" <dave@d...>
wrote:
mains filter mentioned above. Are we talking a capacitor, or is it an
actual item that can be bought. How would I determine the size I
needed? Any other info about this would be great. I thought I was all
ready to start building my supply. DOH! I am also retrofitting a
Bridgeport clone (Tree).
wrote:
> We use the Rutex drives - Power supply can be very simple - just astraight
> isolation transformer with an AC voltage output of say 70 Volts.Couple this to a
> full wave silicon bridge rectifier and electrolytic capacitor ratedat 8.000 to 10,000uf at
> 100 Volt working voltage. This should do the trick - Loads ofcircuits on the web for a
> simple supply - email me if you dont have any luck and I will drawone for you.
>the input
> Couple of other comments, you may want to include a mains filter on
> side of the transformer - this would protect against any shortspikes etc on the mains.
>amps - as long as you
> Use good quality caps with a high ripple current ripple rateing
>
> You may get away with a single mains transformer to drive all 3
> allow for a good current rateing, which should probably be rated at20 Amps.
>I am also a newbie here (long time lurker). My question is about the
> Good luck
>
> Dave Fisher
>
>
mains filter mentioned above. Are we talking a capacitor, or is it an
actual item that can be bought. How would I determine the size I
needed? Any other info about this would be great. I thought I was all
ready to start building my supply. DOH! I am also retrofitting a
Bridgeport clone (Tree).
Discussion Thread
keith
2003-12-11 09:26:42 UTC
loking for help with power supply for rutex drives...
Dave Fisher
2003-12-11 11:37:39 UTC
Re: [CAD_CAM_EDM_DRO] loking for help with power supply for rutex drives...
ckhaun2000
2003-12-11 17:11:02 UTC
Re: loking for help with power supply for rutex drives...
Dave Fisher
2003-12-11 17:41:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: loking for help with power supply for rutex drives...
Mariss Freimanis
2003-12-11 18:52:42 UTC
Re: loking for help with power supply for rutex drives...
John Johnson
2003-12-11 19:13:25 UTC
Re: [CAD_CAM_EDM_DRO] loking for help with power supply for rutex drives...
Dave Fisher
2003-12-11 20:40:45 UTC
Re: [CAD_CAM_EDM_DRO] loking for help with power supply for rutex drives...
David A. Frantz
2003-12-11 21:02:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: loking for help with power supply for rutex drives...
Jon Elson
2003-12-11 22:29:15 UTC
Re: [CAD_CAM_EDM_DRO] loking for help with power supply for rutex drives...
ckhaun2000
2003-12-11 23:03:31 UTC
Re: loking for help with power supply for rutex drives...