Re: [CAD_CAM_EDM_DRO] Question for Kim Lux

on 2003-12-23 08:14:14 UTC

We are running the them with 40 volt supplies, Gecko 320s and US Digital
encoders, 500 CPR. With a 5 TPI ballscrew, this combo gives 1/10,000"
resolution and 150 IPM using TCNC.

If I had to do it over, I'd use 60 or 80V supplies. It sounds like the
new version of TCNC is going to have a much higher stepping rate and
will allow 250 IPM with this sort of set up.

Kim

On Mon, 2003-12-22 at 16:59, ja_erickson wrote:
> Kim,
>
> >From reading the current posts, you say that you have some of the
> Ametek servos and that they work fine for you. Could you
> tell me what voltages and amperages you are using for those 30 volt
> motors and what quadrature count encoders you have? i have those
> motors also and have yet to wire them up. any help would
> be appreciated!
>
> thanks
> jeff
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
> Moderator: pentam@... indigo_red@... davemucha@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Yahoo! Groups Links
>
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/
>
> To unsubscribe from this group, send an email to:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/
--
Kim Lux <lux@...>

Discussion Thread