Re: New user - Which Engraving CAM software is easiest for beginner?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Bill Kichman"
<billkichman@c...> wrote:

> Thanks Fred, but a recommendation for your software from other than

the

> author would be more appropriate. I have tested so much "so

touted" "great"

> software lately my fingers are growing tired.

You are welcome Bill, I think. However you should know that I'm not
the author. I'm just the guy that spends all day, every day,
teaching people like you, how to use software for CNC machining. Do
you think I would recommend software that was not appropriate for
your stated need? And also do you think that others would sit by
idly if I suggested something about some software program that wasn't
so? I offered you the least expensive solution for your stated need,
it also happens to be the best value in Cam-controller software. (the
only suggestion you received too I notice)

If you wanted to know if DeskCNC would do the job for you, you could
have more appropriately followed up with that question instead of
calling my integrity into question. Even better, download the demo
and ask for help on the DeskCNC user forum.

Fred Smith - IMService

We are THE source for low cost Cad-Cam
http://www.imsrv.com/hobby

February special: DeskCNC + Controller Board + Probe $499