Re: Question about VM 4 and Mach2
Posted by
tig415
on 2004-02-12 09:59:36 UTC
Using the VM post process generator open the mach post and select
circles. Check "vector from center to start" button. Then in Mach
under "state" set the IJ mode to "Inc" I'm not sure if this the best
way to output arcs or not but this is what works for me.
Derek
circles. Check "vector from center to start" button. Then in Mach
under "state" set the IJ mode to "Inc" I'm not sure if this the best
way to output arcs or not but this is what works for me.
Derek
Discussion Thread
karl_l_townsend
2004-02-12 05:34:58 UTC
resistor to test stepper pulses
caudlet
2004-02-12 07:09:48 UTC
Re: resistor to test stepper pulses
Jeff Lionberger
2004-02-12 09:04:26 UTC
Question about VM 4 and Mach2
Robert Campbell
2004-02-12 09:41:15 UTC
Re: [CAD_CAM_EDM_DRO] Question about VM 4 and Mach2
tig415
2004-02-12 09:59:36 UTC
Re: Question about VM 4 and Mach2
JanRwl@A...
2004-02-12 17:34:18 UTC
Re: [CAD_CAM_EDM_DRO] resistor to test stepper pulses