Re: Screw Driver

What about something like this: http://www.duraspin.com/ I am not
sure how your screw feeder works but sencos automatic screw guns
work with either philips or square drive.

The only problem I see is you have to use their screws attached to a
track. Doesn't seem like reusing the screws is an option with there
system.

Troy


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Lee Leathers"
<leeleathers@c...> wrote:

> Hello, I am looking to add a mechanism to my cnc project to put

screws in a

> whole.
> I recently purchesed a screw feeder (
> http://cgi.ebay.com/ws/eBayISAPI.dll?

ViewItem&item=2593462914&category=31483&sspagename=STRK%3AMEBWN%
3AIT&rd=1 )

>
> and I was thinking of using an extra stepper motor to place screws

in a pre

> existing 3/16 hole. This will have to all be done automatic (via

software

> programming and the right hardware)...
> oh yeah, also the kicker is, if there is already a screw in the

hole, it

> must remove it until the hole is ready to be closed again with the

screw.

>
> Any suggestions past.. using a magnetic phillips head, would be

much

> appreciated :)
>
> thanks-Lee