Re: Increased power to Gecko 201's
Posted by
bull2002winkle
on 2004-03-06 08:13:44 UTC
Ron:
You are correct to worry a bit. A 70 volt transformer will give you
about 98 volts DC and that's above the 70V G201 rating. The MOSFET's
he uses in the G201 are rated for 100V at 10A but he is conserative
(like all good engineers) and specifies a 70 volt max. A good rule of
thumb is that the DC voltage will about 1.4 times the AC voltage of a
transformer so plan accordingly.
Ken
You are correct to worry a bit. A 70 volt transformer will give you
about 98 volts DC and that's above the 70V G201 rating. The MOSFET's
he uses in the G201 are rated for 100V at 10A but he is conserative
(like all good engineers) and specifies a 70 volt max. A good rule of
thumb is that the DC voltage will about 1.4 times the AC voltage of a
transformer so plan accordingly.
Ken
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Ron K <godsone@e...> wrote:
> Thanks for your answers .
> I found another transformer that gave me 50 volts instead of the 38
> volts and it has made a noticeable difference in the speed and
> acceleration of the mill .
> Oh yes , the higher voltage did not make any difference in the motor
> temperature and I'm still running the Geckos wide open ( no current
set
> resistor )
> PS. I'm a little worried about trying the 70 volt transformer it is
> awfully close to the 80 volt self destruct point .
>
> --
> Ron Kline
>
> American Precision Ceramics
> ge have been removed]
Discussion Thread
Ron K
2004-02-28 13:32:52 UTC
Increased power to Gecko 201's
caudlet
2004-02-28 16:50:56 UTC
Re: Increased power to Gecko 201's
Jon Elson
2004-02-28 22:34:22 UTC
Re: [CAD_CAM_EDM_DRO] Increased power to Gecko 201's
caudlet
2004-02-29 10:00:03 UTC
Re: Increased power to Gecko 201's
Jon Elson
2004-02-29 12:26:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: Increased power to Gecko 201's
Ron K
2004-03-05 21:46:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Increased power to Gecko 201's
bull2002winkle
2004-03-06 08:13:44 UTC
Re: Increased power to Gecko 201's
ibewgypsie
2004-03-06 11:32:49 UTC
Re: Increased power to Gecko 201's
Ron K
2004-03-06 19:06:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Increased power to Gecko 201's
Ron K
2004-03-06 19:06:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Increased power to Gecko 201's
Jon Elson
2004-03-06 21:21:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: Increased power to Gecko 201's
Jon Elson
2004-03-06 21:33:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Increased power to Gecko 201's