I want to cry !!! another fried Gecko + very, very hot motor,

used my mill last night for a few minutes, I made a few very light
cuts, then the machine sat idle for about 30 minutes, I entered a
command and nothing happened, I touched the motor (X is the only axis
hooked up right now) and i burnt myself.....fuse blown as well.

I plugged the wires into a new motor and the trip light immediatly
glowed red.(new fuse)

What am I doing wrong? Is it a setting on the computer that is
causing the motor to overheat? Once the motor overheats, does it fry
the Gecko(s) (340)?? my Y gecko wouldn't work as well

who can i send the powersupply w/geckos, motors and computer to
troubleshoot? I'm about ready to give up !!!!!!


the motors are Litton (Clifton Precision-North)
CPN JDH-2250-FQ-1C
P/N 4798739
D/C 9037
I'm trying to find the specs of these motors, but so far, no luck.

thanks,

Mike Mueller
Antioch, CA