CAD CAM EDM DRO - Yahoo Group Archive

Re: I want to cry !!! another fried Gecko + very, very hot motor,

Posted by Mike Mueller
on 2004-03-12 11:58:16 UTC
after talking to Maraiss, it seems to be the dithering....when
switched on, the motors "talk" quite a bit, I just assumed this was
normal

i still cannot find the exact specs of my motors, but here is what i
believe them to be:

430 oz-in peak torque
1700 rpm rated rpm (i have a 3 to 1 drive ratio on the belts)
40 oz-in rated torque
ballscrews with 5 turns per inch
my encoders have a 500 line count(part number E2-500-197-G)

Discussion Thread

Mike Mueller 2004-03-11 13:31:21 UTC I want to cry !!! another fried Gecko + very, very hot motor, caudlet 2004-03-11 17:39:05 UTC Re: I want to cry !!! another fried Gecko + very, very hot motor, Dave Fisher 2004-03-11 17:40:19 UTC RE: [CAD_CAM_EDM_DRO] I want to cry !!! another fried Gecko + very, very hot motor, Jon Elson 2004-03-11 19:46:52 UTC Re: [CAD_CAM_EDM_DRO] I want to cry !!! another fried Gecko + very, very hot motor, Jon Elson 2004-03-11 19:59:21 UTC Re: [CAD_CAM_EDM_DRO] I want to cry !!! another fried Gecko + very, very hot motor, Mike Mueller 2004-03-12 11:58:16 UTC Re: I want to cry !!! another fried Gecko + very, very hot motor,