Re: Parallel Interface-Breakout Selection
Posted by
turbulatordude
on 2004-03-12 06:11:01 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "efoda5446" <efoda5446@y...>
wrote:
If you are using Gecko's you don't need optos on you step and dir
lines.
Some peole use a db25 connector from radio shack and then solder the
wires in, but that is really low tech.
I built a couple breakout boards, some with LED's, some with relays,
and I keep putting them into a closed box and never see them.
Bottom line is that most any will work just fine. Check the options
and see if you need the options or if they are somehting you will
never use.
Dave
wrote:
> hi there,good
>
> i'm new to the board and am building my first cnc. it's a taig mill
> with 214 oz steppers and pac sci 6410 drives. i'm looking for a
> parallel controller and would appreciate your opinions. these arethe
> ones i have found so far: the axxus, the pmdx, and themay
> campbelldesigns one.
>
> http://members.shaw.ca/axxus/db1v20.htm
> http://www.pmdx.com/PMDX-120/index.html
> http://www.campbelldesigns.com/breakout_board_plus.htm
>
> which is the better board? also, is 4 axis' the limit per lpt,(i
> add a 5th in the future)? any help would really help.These are the top of the line boards with extra bells and whistles.
>
> thanks
> mc
If you are using Gecko's you don't need optos on you step and dir
lines.
Some peole use a db25 connector from radio shack and then solder the
wires in, but that is really low tech.
I built a couple breakout boards, some with LED's, some with relays,
and I keep putting them into a closed box and never see them.
Bottom line is that most any will work just fine. Check the options
and see if you need the options or if they are somehting you will
never use.
Dave
Discussion Thread
efoda5446
2004-03-12 06:03:43 UTC
Parallel Interface-Breakout Selection
turbulatordude
2004-03-12 06:11:01 UTC
Re: Parallel Interface-Breakout Selection
Robert Campbell
2004-03-12 06:40:02 UTC
Re: [CAD_CAM_EDM_DRO] Parallel Interface-Breakout Selection
Ron K
2004-03-12 06:46:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Parallel Interface-Breakout Selection
Les Newell
2004-03-12 06:54:30 UTC
Re: [CAD_CAM_EDM_DRO] Parallel Interface-Breakout Selection
efoda5446
2004-03-12 13:18:35 UTC
Re: Parallel Interface-Breakout Selection
Robert Campbell
2004-03-12 15:22:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Parallel Interface-Breakout Selection
Les Newell
2004-03-13 03:30:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: Parallel Interface-Breakout Selection