RE: [CAD_CAM_EDM_DRO] Hot servo motor

I think I would bet a pitcher of beer that X and Y are cool, but Z is hot.
If so, there are two solutions for this:

1) counterweight
2) use it on the space station, or any other place where gravity might not
apply.

> -----Original Message-----
> From: k8zre [mailto:rfs@...]
> Sent: Friday, April 23, 2004 6:38 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Hot servo motor
>
>
> Mill with three identical servos powered by Rutex drivers. All
> motors tuned and function properly. All run at approx. 6 amps and
> 100 volts. Two motors run cool, one runs hot, even in idle mode.
> Do not feel, see, or hear anything to suggest oscillation or
> otherwise. Comments/suggestions would be appreciated!
>
> Thanx...Richard in Michigan.
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@..., timg@...
> Moderator: pentam@... indigo_red@...
> davemucha@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to
> reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this
> to be a sister site to the CCED group, as many of the same
> members are there, for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY
> POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO
> EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>
>
>