Re: [CAD_CAM_EDM_DRO] Hot servo motor
Posted by
Jon Elson
on 2004-04-28 21:48:08 UTC
k8zre wrote:
the Z axis be causing the motor to draw a lot of current?
Can you swap the cables so that the hot motor is running from a different
Rutex axis? Does the hot condition stay with the motor or the Rutex drive?
Jon
>Mill with three identical servos powered by Rutex drivers. AllIs the hot one the Z axis? Could the weight of whatever is hanging on
>motors tuned and function properly. All run at approx. 6 amps and
>100 volts. Two motors run cool, one runs hot, even in idle mode.
>Do not feel, see, or hear anything to suggest oscillation or
>otherwise. Comments/suggestions would be appreciated!
>
>
the Z axis be causing the motor to draw a lot of current?
Can you swap the cables so that the hot motor is running from a different
Rutex axis? Does the hot condition stay with the motor or the Rutex drive?
Jon
Discussion Thread
k8zre
2004-04-23 16:38:20 UTC
Hot servo motor
Roy J. Tellason
2004-04-23 17:13:38 UTC
Re: [CAD_CAM_EDM_DRO] Hot servo motor
JanRwl@A...
2004-04-23 18:33:26 UTC
Re: [CAD_CAM_EDM_DRO] Hot servo motor
Andy Wander
2004-04-23 18:48:49 UTC
RE: [CAD_CAM_EDM_DRO] Hot servo motor
Greg Jackson
2004-04-23 20:08:40 UTC
RE: [CAD_CAM_EDM_DRO] Hot servo motor
k8zre
2004-04-23 20:27:44 UTC
Re: Hot servo motor
chamonix_coupe
2004-04-24 08:55:50 UTC
Re: Hot servo motor
Peter Renolds
2004-04-24 14:55:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hot servo motor
k8zre
2004-04-24 18:02:40 UTC
Re: Hot servo motor
k8zre
2004-04-27 16:09:58 UTC
Re: Hot servo motor
Fred Smith
2004-04-27 16:41:33 UTC
Re: Hot servo motor
Peter Reilley
2004-04-27 20:06:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hot servo motor
Jon Elson
2004-04-28 21:48:08 UTC
Re: [CAD_CAM_EDM_DRO] Hot servo motor
Jon Elson
2004-04-28 22:04:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hot servo motor
k8zre
2004-04-29 04:50:24 UTC
Re: Hot servo motor
Jon Elson
2004-04-29 09:19:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hot servo motor