Re: Hot servo motor

If the Y gib adjustment is too tight then there would be more load on
that motor causing higher current draw and heat on that axis. The
servo driver should deliver as much as needed under load, even
sometimes at the expense of the motor (or driver).
Regards

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "k8zre" <rfs@c...> wrote:
> Hmmmmm....make that a pitcher of rootbeer, please. The hot servo
> axis is Y. All of the drivers and all of the servos are identical.
> I will swap and see what happens. Thanx for the suggestions.
> (Using MACH2(exciting) with Campbell breakout board (nice).)
> Best Regards...Richard in Michigan.
>