Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Posted by
Art
on 2004-05-08 10:42:44 UTC
Hi Erie:
Wire the A and B quadrature lines to the port and connect the 0 volt line
to pin 25. Mach2 will then track the encoders..
Config/Encoders is used to calibrate the pulses per unit.
Thanks,
Art
www.artofcnc.ca
Wire the A and B quadrature lines to the port and connect the 0 volt line
to pin 25. Mach2 will then track the encoders..
Config/Encoders is used to calibrate the pulses per unit.
Thanks,
Art
www.artofcnc.ca
Discussion Thread
alanganes
2004-05-06 04:01:09 UTC
EMC as DRO?
erie
2004-05-06 06:10:52 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Ron K
2004-05-06 07:58:40 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
erie
2004-05-06 08:01:59 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Jon Elson
2004-05-06 08:32:40 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
David A. Frantz
2004-05-06 11:26:54 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Jon Elson
2004-05-06 22:14:03 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Raymond Heckert
2004-05-07 16:57:03 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Jon Elson
2004-05-07 21:27:43 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?
Art
2004-05-08 10:42:44 UTC
Re: [CAD_CAM_EDM_DRO] EMC as DRO?