Re: [CAD_CAM_EDM_DRO] No Torque (power?)

On Thursday 20 May 2004 10:02 pm, Andy Wander spake:

> With a bigger pulley on the motor and a smaller one on the leadscrew, it
> will go FASTER with LESS torque. You should swap the pulleys, and it will
> go SLOWER with More torque.

I understand about the bigger pulley/smaller pulley issue, but my
point is that it's not an issue *yet* because you can stall the motors
with two fingers with less pressure than opening a door knob at this
point, *without* them hooked up to anything.

> What speed are you turning the motors at when you stop them by hand? Slow
> them down andd see what happens.

It's seemingly irrevlevant of speed at this time.

Thanks,

Weyland