RE: plasma cutter
Posted by
rfs@c...
on 2000-04-25 04:59:18 UTC
I have been following the discussion re: x/y mechanism for plasma
cutter table. Mention was made about TorchMate. Their rack and
pinion drive mechanism appears to be straight forward. The unit uses
cold rolled steel 1 inch square bar as x axis track (sitting on 2
inch
square 1/8 inch steel stock). 3/4 by 2-3 inch cold rolled steel
bar as track for y axis. Cam followes are use to roll around on and
keep the unit tight against the cold rolled steel bars. The unit
gets
very good resolution! I would like to find a good source for the
rack
(gear track), everything else is readily available. rfs.
cutter table. Mention was made about TorchMate. Their rack and
pinion drive mechanism appears to be straight forward. The unit uses
cold rolled steel 1 inch square bar as x axis track (sitting on 2
inch
square 1/8 inch steel stock). 3/4 by 2-3 inch cold rolled steel
bar as track for y axis. Cam followes are use to roll around on and
keep the unit tight against the cold rolled steel bars. The unit
gets
very good resolution! I would like to find a good source for the
rack
(gear track), everything else is readily available. rfs.
Discussion Thread
rfs@c...
2000-04-25 04:59:18 UTC
RE: plasma cutter
turksfixit
2002-01-09 19:15:49 UTC
plasma cutter
skronaldd
2002-01-12 11:43:22 UTC
Re: plasma cutter
turksfixit
2002-01-12 20:33:50 UTC
RE: [CAD_CAM_EDM_DRO] Re: plasma cutter
Chris Clough
2002-01-12 21:12:18 UTC
FS: Hypertherm Powermax 380 Plasma Cutter
Raymond Heckert
2002-01-12 21:24:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: plasma cutter
turksfixit
2002-01-12 21:46:50 UTC
RE: [CAD_CAM_EDM_DRO] Re: plasma cutter
Chris L
2002-01-13 08:28:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: plasma cutter
geneinsa
2002-01-13 09:26:12 UTC
Re: plasma cutter
aspaguy
2002-01-13 18:37:52 UTC
Re: plasma cutter
ian092680
2002-01-26 10:07:57 UTC
Re: FS: Hypertherm Powermax 380 Plasma Cutter
Chris Clough
2002-01-26 10:11:10 UTC
RE: [CAD_CAM_EDM_DRO] Re: FS: Hypertherm Powermax 380 Plasma Cutter
Ian Kaminski
2002-01-26 12:34:31 UTC
RE: [CAD_CAM_EDM_DRO] Re: FS: Hypertherm Powermax 380 Plasma Cutter