Re: [CAD_CAM_EDM_DRO] EMC Parallel port config, please help
Posted by
Alan Marconett
on 2004-06-02 11:14:44 UTC
Hi Lance,
To change pins around, get a RS-232 type patch box, or wire up a short
M-F DB25 cable. About all you can do for EMC, I think. I have the same
problem, I wired my drivers for the MaxNC pinout, which has step/dir
pins the reverse of EMC's.
Alan KM6VV
Lance Hopper wrote:
To change pins around, get a RS-232 type patch box, or wire up a short
M-F DB25 cable. About all you can do for EMC, I think. I have the same
problem, I wired my drivers for the MaxNC pinout, which has step/dir
pins the reverse of EMC's.
Alan KM6VV
Lance Hopper wrote:
> Hello,
> Just got BDI TNG (RH7.2 based) EMC running. Trying to hook it up
> to an older stepper motor controller. I need to swap some of my
> outputs
> in EMC to work with my controller. For example, the direction/step
> outputs are opposite of what I need (step/dir). I also
> need to map my init (turn power on to motors) to pin 16 and high
> power (high/low power for when
> motors are at rest) to pin 17 etc... The emc.ini file only has
> auxillary
> stuff like coolant/spindle etc... I don't see anywhere that you can
> change step/dir etc.. Any help would be greatly appreciated.
>
>
Discussion Thread
Lance Hopper
2004-06-02 11:08:17 UTC
EMC Parallel port config, please help
Alan Marconett
2004-06-02 11:14:44 UTC
Re: [CAD_CAM_EDM_DRO] EMC Parallel port config, please help
Lance Hopper
2004-06-02 11:38:08 UTC
Re: EMC Parallel port config, please help
Peter Linss
2004-06-02 17:16:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Parallel port config, please help
Jon Elson
2004-06-02 22:42:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Parallel port config, please help
Lance Hopper
2004-06-03 04:17:23 UTC
Re: EMC Parallel port config, please help
Jon Elson
2004-06-03 09:15:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Parallel port config, please help
JanRwl@A...
2004-06-03 20:55:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Parallel port config, please help
Lance Hopper
2004-06-04 04:50:15 UTC
Re: EMC Parallel port config, please help
Lance Hopper
2004-06-04 08:59:29 UTC
Re: EMC Parallel port config, please help
Jon Elson
2004-06-04 10:28:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Parallel port config, please help