CAD CAM EDM DRO - Yahoo Group Archive

Plasma Cutter recommendations

Posted by Thomas Powell
on 2004-06-27 13:27:56 UTC
I am looking for a plasma cutter for my shop. Not going to use it for CNC
but this info might be used by others who may so I hope this is not too far
off topic.

Looking for dual 110/220 voltage, capable of severing up to 1/2" aluminum.

Any suggestions??

Thanks,

Thomas

Discussion Thread

Thomas Powell 2004-06-27 13:27:56 UTC Plasma Cutter recommendations josef wagner 2004-06-27 23:31:50 UTC Re: [CAD_CAM_EDM_DRO] Plasma Cutter recommendations STAN MCDONALD 2004-06-28 12:49:47 UTC Re: [CAD_CAM_EDM_DRO] Plasma Cutter recommendations Hal Eckhart 2004-06-28 15:37:23 UTC Re: [CAD_CAM_EDM_DRO] Plasma Cutter recommendations jimmyge2001 2004-06-29 07:56:21 UTC Re: Plasma Cutter recommendations Todd W. Syssa 2004-06-29 08:55:36 UTC Re: [CAD_CAM_EDM_DRO] Re: Plasma Cutter recommendations Tad Johnson 2004-06-29 14:26:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Plasma Cutter recommendations Thomas Powell 2004-06-29 19:51:01 UTC Re: [CAD_CAM_EDM_DRO] Re: Plasma Cutter recommendations