CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5

Posted by Les Newell
on 2004-08-09 00:41:00 UTC
I certainly found half winding worked best on mine.

Les


> use most of these motors, half-winding or full winding. The original
> unipolar
> drive was effectively half-winding at 8.7 A or something like that. So,
> you could
> use a Gecko drive across the full winding at 4.3 A or half winding at 7 A.
> I think it has been determined that half winding at 7 A gives the best
> performance.
>
> Jon
>
>

Discussion Thread

rocketscientistnate 2004-01-13 15:18:03 UTC Bridgeport Boss 5 jlsmith269 2004-01-14 05:45:26 UTC Re: Bridgeport Boss 5 cncgramps 2004-01-14 06:29:53 UTC Re: Bridgeport Boss 5 rocketscientistnate 2004-08-08 12:21:25 UTC Bridgeport Boss 5 Les Newell 2004-08-08 13:31:19 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Jon Elson 2004-08-08 14:14:22 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Robert Williams 2004-08-08 15:04:57 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Statman Designs, LLC 2004-08-08 15:08:51 UTC RE: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Roy J. Tellason 2004-08-08 15:45:04 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Dan Quinn 2004-08-08 19:18:09 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Shawncd 2004-08-08 19:52:07 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Jon Elson 2004-08-08 20:39:58 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5 Les Newell 2004-08-09 00:41:00 UTC Re: [CAD_CAM_EDM_DRO] Bridgeport Boss 5