Re: Analog Output controller?
Posted by
vavaroutsos
on 2004-09-10 22:39:19 UTC
Take a look at EMC
www.linuxcnc.org
and the PCI card from Vital Systems
www.vitalsystem.com
~petev
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jracingrc" <jracingrc@y...>
wrote:
www.linuxcnc.org
and the PCI card from Vital Systems
www.vitalsystem.com
~petev
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jracingrc" <jracingrc@y...>
wrote:
> Hi guys,
>
> I have 3 of these AMC Servo Amplifiers B30A8:
> http://www.a-m-c.com/products/trap.htm
>
> I was wondering, how do I get these to control the motor? I think
> they need an analog output controller to send a +/- 10V command
> signal, but I'm really in the dark about these things. I've
> seen "motion controllers" on ebay, but I'm not sure how I go about
> connecting those things to the AMC amplifiers I have. Are there any
> relatively inexpensive controllers that I can use with these
> amplifiers??
>
> Ideally I'd like to have closed loop, where the computer knows the
> position of the motors, but open loop like the stepper systems is
> fine too.
>
> Thanks very much!
Discussion Thread
jracingrc
2004-09-10 21:42:08 UTC
Analog Output controller?
vavaroutsos
2004-09-10 22:39:19 UTC
Re: Analog Output controller?
Jon Elson
2004-09-10 23:16:52 UTC
Re: [CAD_CAM_EDM_DRO] Analog Output controller?
Brad Eyben
2004-09-11 07:08:09 UTC
Re: [CAD_CAM_EDM_DRO] Analog Output controller?
Peter Renolds
2004-09-11 07:59:07 UTC
Re: [CAD_CAM_EDM_DRO] Analog Output controller?
vrsculptor
2004-09-11 08:42:44 UTC
Re: Analog Output controller?
Jon Elson
2004-09-11 09:33:12 UTC
Re: [CAD_CAM_EDM_DRO] Analog Output controller?
Jon Elson
2004-09-11 09:36:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Analog Output controller?
R Rogers
2004-09-11 12:03:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Analog Output controller?
Jon Elson
2004-09-11 15:03:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: Analog Output controller?
erie
2004-09-11 15:11:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: Analog Output controller?
Brad Eyben
2004-09-12 02:58:48 UTC
Re: [CAD_CAM_EDM_DRO] Analog Output controller?
stepperman
2004-09-12 19:38:40 UTC
Re: Analog Output controller?
Jon Elson
2004-09-12 22:08:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: Analog Output controller?
Paul
2004-09-13 01:08:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: Analog Output controller?