(no subject)
Posted by
GRautoHP@a...
on 2004-09-25 14:56:32 UTC
I have a milltronics partner knee mill with a bad controller and I was
wanting to build a pc based controller using rutex drivers. has anyone done this
before that has put together PLANS and a MATERIAL LIST of what I would need and
how to do it.
I have motor s and encoders and what is left of the old control.
[Non-text portions of this message have been removed]
wanting to build a pc based controller using rutex drivers. has anyone done this
before that has put together PLANS and a MATERIAL LIST of what I would need and
how to do it.
I have motor s and encoders and what is left of the old control.
[Non-text portions of this message have been removed]
Discussion Thread
GRautoHP@a...
2004-09-25 14:56:32 UTC
(no subject)
alphawolf45
2004-09-25 16:36:48 UTC
Re: (no subject)