PC based Controllers....
Posted by
doug98105
on 2004-11-04 11:30:12 UTC
Group,
Do any of the hobby PC based controls support coordinate rotation
and scaling, also subroutines? These are a couple of features I'd
like in the controller I want to use on a small Dyna mill.
I've looked at the sites of a few of these type controls in the past
and there wasn't much specific info on their features. so I'll do
it the lazy way and ask you guys.
thanks,
Doug
Do any of the hobby PC based controls support coordinate rotation
and scaling, also subroutines? These are a couple of features I'd
like in the controller I want to use on a small Dyna mill.
I've looked at the sites of a few of these type controls in the past
and there wasn't much specific info on their features. so I'll do
it the lazy way and ask you guys.
thanks,
Doug
Discussion Thread
doug98105
2004-11-04 11:30:12 UTC
PC based Controllers....
Andy Wander
2004-11-04 11:35:46 UTC
RE: [CAD_CAM_EDM_DRO] PC based Controllers....
Chuck Rice
2004-11-04 11:58:41 UTC
Re: [CAD_CAM_EDM_DRO] PC based Controllers....
Tom Hubin
2004-11-04 13:18:52 UTC
Re: [CAD_CAM_EDM_DRO] PC based Controllers....
Fred Smith
2004-11-04 14:05:56 UTC
Re: PC based Controllers....