Re: [CAD_CAM_EDM_DRO] PC based Controllers....
Posted by
Tom Hubin
on 2004-11-04 13:18:52 UTC
doug98105 wrote:
TurboCnc 3.1a and upward uses subroutines. TurboCnc 4.0 also has
variables, and primitive looping. Variables can be used for scaling and
offsets. TurboCnc is inexpensive shareware with fully functional free
download. It runs under DOS on anything with a coprocessor from an 80486
66MHz or better.
Tom Hubin
thubin@...
>Hello Doug,
> Group,
>
> Do any of the hobby PC based controls support coordinate rotation
> and scaling, also subroutines? These are a couple of features I'd
> like in the controller I want to use on a small Dyna mill.
>
> I've looked at the sites of a few of these type controls in the past
> and there wasn't much specific info on their features. so I'll do
> it the lazy way and ask you guys.
>
> thanks,
>
> Doug
TurboCnc 3.1a and upward uses subroutines. TurboCnc 4.0 also has
variables, and primitive looping. Variables can be used for scaling and
offsets. TurboCnc is inexpensive shareware with fully functional free
download. It runs under DOS on anything with a coprocessor from an 80486
66MHz or better.
Tom Hubin
thubin@...
Discussion Thread
doug98105
2004-11-04 11:30:12 UTC
PC based Controllers....
Andy Wander
2004-11-04 11:35:46 UTC
RE: [CAD_CAM_EDM_DRO] PC based Controllers....
Chuck Rice
2004-11-04 11:58:41 UTC
Re: [CAD_CAM_EDM_DRO] PC based Controllers....
Tom Hubin
2004-11-04 13:18:52 UTC
Re: [CAD_CAM_EDM_DRO] PC based Controllers....
Fred Smith
2004-11-04 14:05:56 UTC
Re: PC based Controllers....