Re: [CAD_CAM_EDM_DRO] DeskNC board repair
Posted by
Alan Marconett
on 2004-11-10 12:46:22 UTC
Hi Dave,
I had the 5V regulator go week. The +5V line dropped to about 3 volts.
I noticed it when one of the three Geckos I was also powering off the
regulator started to ignore my step commands.
Alan KM6VV
turbulatordude wrote:
I had the 5V regulator go week. The +5V line dropped to about 3 volts.
I noticed it when one of the three Geckos I was also powering off the
regulator started to ignore my step commands.
Alan KM6VV
turbulatordude wrote:
>
> Hi all,
>
> a friend thinkis he blew up his DeskNC board (ver 1.38)
>
> I told him I'd take a look at it to see if there is any obvious
> problems.
>
> HAs anyone ever fixed one of these ?
>
> Any recomendatoins on what to look for ? or the best way to
> proceede ?
>
> Thanks in advance
>
> Dave
>
Discussion Thread
turbulatordude
2004-11-10 06:59:23 UTC
DeskNC board repair
Kenneth Cardolino
2004-11-10 09:26:58 UTC
Re: DeskNC board repair
Alan Marconett
2004-11-10 12:46:22 UTC
Re: [CAD_CAM_EDM_DRO] DeskNC board repair