Re: Anyone using JR-Kerr?

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:

>
> For the stuff at work brushless motors might be the way we go and
> these drives do that however it is a little worrying if they do not
> except commands as they should if that is still the case. We would
> be using our own software for this.
>
> I hadn't been able to get much general info on the Imserv servo
> drives from the site, anyone using these?

Our drives take step and direction, use 5v quadrature encoders, are
rated at 5 amps and 30 volts max, use pm brushed servo motors, and
have over temp and over current protection. We also have a compact
power supply kit, and sell a line of Globe pm dc servo motors with or
without belt reduction drives that are well matched for use on
Sherline, Taig, and similar sized benchtop cnc machines. What other
information would you like? We are also temporarily sold out ....

Next week we will release a 2nd generation board with approx a 20%
reduction in size, and header connections instead of screw terminals.

Fred Smith - IMService
http://www.cadcamcadcam.com/hobby