Re: [CAD_CAM_EDM_DRO] Re: simple (low cost) encoder readout software ?

Dave,
Yes, this is the set up for the full blown dro. I thought you were also
asking about software to accomplish an end as well as checking out what you
had.

Sorry if I misunderstood.

Bubba

At 11:01 AM 11/15/2004, you wrote:

>--- In CAD_CAM_EDM_DRO@yahoogroups.com, "A. G. Eckstein"
><a_eckstein@b...> wrote:
> > Dave,
> > Once you figure out what you have, I have freeware on my web site
>to give a
> > readout of the results on a computer monitor. It takes a simple
>interface
> > and hooks to the parallel port for the reading.
> >
> > You will find the site in my tag line.
> >
> > Let me know if I can help.
> >
> > Bubba
>
>Looking at the schematic, you have 4 encoders. each goes to a 7414
>that then goes to two pins on the parallel port.
>
>Each also goes to a network that takes all the outputs down to a
>couple pins on the parallel port.
>
>Is that network to trigger the software to update ?
>
>Since I will probably just connect an encoder and spin it one
>revolution to see the count I don't need too much sophistacation.(sp?)
>
>Dave
>
>

Bubba

OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
In God We Trust

http://bellsouthpwp.net/A/r/Arts_home_page/DRO/

LaGrange, GA




[Non-text portions of this message have been removed]