CAD CAM EDM DRO - Yahoo Group Archive

Re: simple (low cost) encoder readout software ?

on 2004-11-15 17:01:17 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "A. G. Eckstein"
<a_eckstein@b...> wrote:
> Dave,
> Yes, this is the set up for the full blown dro. I thought you were
also
> asking about software to accomplish an end as well as checking out
what you
> had.
>
> Sorry if I misunderstood.
>
> Bubba

I see that the full blown DRO is a very simple application. Since
it is so simple, I may just put one on my 9" SB lathe.

I'll have to wait and see how many, and of what range encoders I have.


Dave

Discussion Thread

turbulatordude 2004-11-14 08:22:13 UTC simple (low cost) encoder readout software ? Roy J. Tellason 2004-11-14 08:40:15 UTC Re: [CAD_CAM_EDM_DRO] simple (low cost) encoder readout software ? caudlet 2004-11-14 09:43:01 UTC Re: simple (low cost) encoder readout software ? Roy J. Tellason 2004-11-14 11:22:10 UTC Re: [CAD_CAM_EDM_DRO] Re: simple (low cost) encoder readout software ? A. G. Eckstein 2004-11-14 13:28:26 UTC Re: [CAD_CAM_EDM_DRO] simple (low cost) encoder readout software ? turbulatordude 2004-11-14 14:30:07 UTC Re: simple (low cost) encoder readout software ? turbulatordude 2004-11-15 08:02:13 UTC Re: simple (low cost) encoder readout software ? A. G. Eckstein 2004-11-15 12:09:41 UTC Re: [CAD_CAM_EDM_DRO] Re: simple (low cost) encoder readout software ? turbulatordude 2004-11-15 17:01:17 UTC Re: simple (low cost) encoder readout software ?