Re: [CAD_CAM_EDM_DRO] need motor specs

On Sunday 14 November 2004 09:00 pm, Jon Elson wrote:

> Keith Bowers wrote:
> >On Sunday 14 November 2004 06:14 pm, Jon Elson wrote:
> >>Bob Muse wrote:
> >>>Hi Jon
> >>>I think that Control Systems Research, or CSR, became Contraves or was
> >>>bought by them or something.
> >>
> >>Thanks. I didn't find anything about older models there. The serial #,
> >>and the machine makes me think 77 may be the year code. Does anyone know
> >>where I might find data on these motors?
> >>
> >>Thanks again,
> >>
> >>Jon
> >
> >That date sounds like the original two-axis machine. FWIW the power supply
> > on mine is 50 Volts. I don't know about the current.
>
> You HAVE one? Yes, I'm sure these are the original motors. Any info
> you can provide,
> maybe even pictures of the electronics, might be helpful.
>
> Thanks,
>
> Jon
>

Jon,
E-mail me directly (kadontneedthisbowers@...) removing the
trash from the address and I will reply with a picture I filched off a used
machine dealer's WEB site. It matches mine, except that I don't have the
coolant pump. If it's the right machine I'll try to take some shots of the
guts and send them. At present it's stashed in the back of my garage and hard
to get to. I should have my new shop ready for it before Christmas; then I
can finally start working on it. The only documentation I have is a poor
photocopy of the programming manual.
--
Keith Bowers - Thomasville, NC