CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] need motor specs

Posted by Jon Elson
on 2004-11-14 18:00:44 UTC
Keith Bowers wrote:

>On Sunday 14 November 2004 06:14 pm, Jon Elson wrote:
>
>
>>Bob Muse wrote:
>>
>>
>>>Hi Jon
>>>I think that Control Systems Research, or CSR, became Contraves or was
>>>bought by them or something.
>>>
>>>
>>Thanks. I didn't find anything about older models there. The serial #,
>>and the machine makes me think 77 may be the year code. Does anyone know
>>where I might find data on these motors?
>>
>>Thanks again,
>>
>>Jon
>>
>>
>>
>>
>>
>That date sounds like the original two-axis machine. FWIW the power supply on
>mine is 50 Volts. I don't know about the current.
>
>
You HAVE one? Yes, I'm sure these are the original motors. Any info
you can provide,
maybe even pictures of the electronics, might be helpful.

Thanks,

Jon

Discussion Thread

Jon Elson 2004-11-14 12:05:00 UTC need motor specs Bob Muse 2004-11-14 12:12:33 UTC Re: [CAD_CAM_EDM_DRO] need motor specs Jon Elson 2004-11-14 15:14:46 UTC Re: [CAD_CAM_EDM_DRO] need motor specs Dan Mauch 2004-11-14 15:49:54 UTC Re: [CAD_CAM_EDM_DRO] need motor specs Keith Bowers 2004-11-14 15:53:16 UTC Re: [CAD_CAM_EDM_DRO] need motor specs Jon Elson 2004-11-14 18:00:44 UTC Re: [CAD_CAM_EDM_DRO] need motor specs Jon Elson 2004-11-14 21:07:52 UTC Re: [CAD_CAM_EDM_DRO] need motor specs Keith Bowers 2004-11-16 16:56:01 UTC Re: [CAD_CAM_EDM_DRO] need motor specs