Re: GCODE FOR DB9
Posted by
kdoney_63021
on 2004-12-12 15:33:34 UTC
Thanks. I think a post to the files section is reasonable.
Kevin
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "A. G. Eckstein"
<a_eckstein@b...> wrote:
Kevin
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "A. G. Eckstein"
<a_eckstein@b...> wrote:
> Kevin,G=code
> I have the db9 and db25 cutouts in both cad and G-code. I found the
> on one of the group sites (Turbocnc if I remember) and then found aprogram
> that will read G-cod back into cad.section. Your
>
> I can either mail them directly to you or put up in the files
> choice.db9
>
> Bubba
>
> At 01:33 PM 12/12/2004, you wrote:
>
>
> >Anyone have, or know where I can get, the gcode for milling out a
> >hole? I would also like the other db profiles.
> >KEvin
> >
>
> Bubba
>
> OLDER THAN DIRT
> Country Bubba
> (Actually the inventor of Country and Bubba)
> In God We Trust
>
> LaGrange, GA
>
> http://bellsouthpwp.net/A/r/Arts_home_page/cnc/
>
> [Non-text portions of this message have been removed]
Discussion Thread
kdoney_63021
2004-12-12 10:33:42 UTC
GCODE FOR DB9
Robert Campbell
2004-12-12 12:12:57 UTC
Re: [CAD_CAM_EDM_DRO] GCODE FOR DB9
A. G. Eckstein
2004-12-12 13:55:26 UTC
Re: [CAD_CAM_EDM_DRO] GCODE FOR DB9
kdoney_63021
2004-12-12 15:33:34 UTC
Re: GCODE FOR DB9
A. G. Eckstein
2004-12-12 17:19:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9
john labutski
2004-12-12 18:37:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9
John Dammeyer
2004-12-12 23:45:33 UTC
RE: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9
A. G. Eckstein
2004-12-13 03:50:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9