Re: [CAD_CAM_EDM_DRO] GCODE FOR DB9
Posted by
A. G. Eckstein
on 2004-12-12 13:55:26 UTC
Kevin,
I have the db9 and db25 cutouts in both cad and G-code. I found the G=code
on one of the group sites (Turbocnc if I remember) and then found a program
that will read G-cod back into cad.
I can either mail them directly to you or put up in the files section. Your
choice.
Bubba
At 01:33 PM 12/12/2004, you wrote:
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
In God We Trust
LaGrange, GA
http://bellsouthpwp.net/A/r/Arts_home_page/cnc/
[Non-text portions of this message have been removed]
I have the db9 and db25 cutouts in both cad and G-code. I found the G=code
on one of the group sites (Turbocnc if I remember) and then found a program
that will read G-cod back into cad.
I can either mail them directly to you or put up in the files section. Your
choice.
Bubba
At 01:33 PM 12/12/2004, you wrote:
>Anyone have, or know where I can get, the gcode for milling out a db9Bubba
>hole? I would also like the other db profiles.
>KEvin
>
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
In God We Trust
LaGrange, GA
http://bellsouthpwp.net/A/r/Arts_home_page/cnc/
[Non-text portions of this message have been removed]
Discussion Thread
kdoney_63021
2004-12-12 10:33:42 UTC
GCODE FOR DB9
Robert Campbell
2004-12-12 12:12:57 UTC
Re: [CAD_CAM_EDM_DRO] GCODE FOR DB9
A. G. Eckstein
2004-12-12 13:55:26 UTC
Re: [CAD_CAM_EDM_DRO] GCODE FOR DB9
kdoney_63021
2004-12-12 15:33:34 UTC
Re: GCODE FOR DB9
A. G. Eckstein
2004-12-12 17:19:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9
john labutski
2004-12-12 18:37:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9
John Dammeyer
2004-12-12 23:45:33 UTC
RE: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9
A. G. Eckstein
2004-12-13 03:50:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: GCODE FOR DB9