Re: [CAD_CAM_EDM_DRO] Power supply options
Posted by
Roy J. Tellason
on 2005-01-28 12:38:18 UTC
On Friday 28 January 2005 03:08 pm, Scott Riddle wrote:
from the power line. If not, you're looking at a serious safety hazard,
there.
> I have a variable speed DC power supply for a DC brush motor. ItMy main concern with that would be whether or not that supply is _isolated_
> takes 110AC 10A and outputs 0-130V DC 8Amps. Can this be used as a
> variable voltage supply to power stepper motors? I like the voltage
> adjustability and ability to go to the 40-60 volt range. I found
> these DC motor speed controlers in a surplus catalog and they are
> only about $30.
> Please let me know if I am all wet or missing a bigger piece of the
> picture.
from the power line. If not, you're looking at a serious safety hazard,
there.
Discussion Thread
Scott Riddle
2005-01-28 12:08:28 UTC
Power supply options
Roy J. Tellason
2005-01-28 12:38:18 UTC
Re: [CAD_CAM_EDM_DRO] Power supply options
Alan Marconett
2005-01-28 13:02:47 UTC
Re: [CAD_CAM_EDM_DRO] Power supply options
Scott Riddle
2005-01-28 13:13:49 UTC
Re: Power supply options
Alan Marconett
2005-01-28 13:31:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power supply options
Scott Riddle
2005-01-28 14:51:52 UTC
Re: Power supply options
Codesuidae
2005-01-28 15:06:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power supply options
knives01us
2005-01-29 02:51:48 UTC
Re: Power supply options / use PWM DC motor controller?
caudlet
2005-01-30 06:03:56 UTC
Re: Power supply options / use PWM DC motor controller?
AbbyKatt
2005-01-30 06:30:47 UTC
Rewiring a mill to auto-start on power?
Stephen Wille Padnos
2005-01-30 08:21:38 UTC
Re: [CAD_CAM_EDM_DRO] Rewiring a mill to auto-start on power?
Alan Marconett
2005-01-30 13:07:25 UTC
Re: [CAD_CAM_EDM_DRO] Rewiring a mill to auto-start on power?