Re: x-former question
Posted by
jlsmith269
on 2005-02-15 06:08:57 UTC
to clarify,
this is the step down transformer that runs the DC side.. 60V for
the mill.
This is NOT to be the operation/head/spindle side... that's on a VFD
jeffe
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jlsmith269"
<jlsmith269@y...> wrote:
this is the step down transformer that runs the DC side.. 60V for
the mill.
This is NOT to be the operation/head/spindle side... that's on a VFD
jeffe
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jlsmith269"
<jlsmith269@y...> wrote:
>legs)
> Okay, I bought a hurco KM1.. the mains where wired for 440 (i hve
> wiring diagrams)that can run from either 440 (2 phases into 2
> or 220 (2 phases into 4 legs)
>
> question is
>
> would i let the smoke out of it if I wanted to run it off single
> phase, using each leg as a phase?
>
> jeffe
Discussion Thread
jlsmith269
2005-02-14 20:03:29 UTC
x-former question
jlsmith269
2005-02-15 06:08:57 UTC
Re: x-former question
John Delaney
2005-02-15 22:07:16 UTC
Re: x-former question