Re: [CAD_CAM_EDM_DRO] Re: Need help with Dyno design

I agree, although it would mimic the acceleration and velocity of moving a mass such as a machine table or gantry. Acceleration could be adjusted in the software. If the test revealed that the load could not be accelerated to speed, the continual torque at set velocity would be irrelevant. So, actually it would be a device to measure the acceleration of a specified load in a predetermined duration.

Ron

Steve Stallings <stevesng@...> wrote:


Doing a dyno with a moving mass gets tricky because
it takes some of the torque to accelerate the mass.
You will need enough range of motion to reach the
steady state speed without the stepper motor jumping
steps while accelerating or possibly use a linear
acceleration and calculate the additional torque
consumed in the acceleration.

Regards,
Steve Stallings


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
wrote:

>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, R Rogers
> wrote:
> > Wally, Wouldn't it be easier to turn a 2"long X 2.125 dia spool

in

> the lathe with a 16 tpi groove on its diameter. Mount spool on

motor

> shaft, wind a cable on the spool with different weights suspended
> from it? Steel is .282 pounds per cubic inch to calculate the
> standards. Run different Rpm's and distances to see where it skips.
> Could run that Eckstein's DRO system with an encoder mounted on

shaft

> to verify. Or a simple reference mark from shaft to motor body.
> >
> > Ron
>
> I was thinking of a simple home version. A motor mount, a pulley

as

> you described, possibly a 1" screw as the spool, and a pulley on

the

> ceiling with a rope to a bucket.
>
> add water, nuts and bolts, or whatever.
>
> you can mark the height that the ramping ends and run tests on that.
>
> Since most steppers fail entirly when missing steps, it would be
> interesting to see.
>
> I also though about adding washers on a string so as the bucket

kept

> moving it would have weights added automatically.
>
> Dave

Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com

Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
Moderator: pentam@... indigo_red@... davemucha@... [Moderators]
URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO

OFF Topic POSTS: General Machining
If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
http://www.metalworking.com/news_servers.html

http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.

NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
bill
List Mom
List Owner


Yahoo! Groups Links









[Non-text portions of this message have been removed]