CAD CAM EDM DRO - Yahoo Group Archive

Mach III and DeskCNC

Posted by Will
on 2005-02-21 08:21:39 UTC
I have been debating on which of these machine controllers I want to
use. My problem is that I really like the Cam and the digitizing that
DeskCNC offers, but I am going to run it on a Shoptask machine. I
really need a lathe contoller. It doesnt have to be a fancy one, but
I need to be able to cut threads. My question is this, can I use more
than one type of controller with the DeskCnc hardware? If so, which
ones are compatible?
William

Discussion Thread

Will 2005-02-21 08:21:39 UTC Mach III and DeskCNC Fred Smith 2005-02-21 12:02:14 UTC Re: Mach III and DeskCNC John Stevenson 2005-02-21 15:09:09 UTC Re: Mach III and DeskCNC Will 2005-02-21 18:06:32 UTC Re: Mach III and DeskCNC Will 2005-02-25 15:46:38 UTC Re: Mach III and DeskCNC ballendo 2005-02-27 07:46:32 UTC Re: Mach III and DeskCNC John Stevenson 2005-02-27 08:02:48 UTC Re: Mach III and DeskCNC Will 2005-02-27 08:41:55 UTC Re: Mach III and DeskCNC John Stevenson 2005-02-27 09:04:24 UTC Re: Mach III and DeskCNC