Re: Mach III and DeskCNC
Posted by
Will
on 2005-02-21 18:06:32 UTC
Thank you so much for your reply. I had been looking at the DeskCNC
website and found no mention of using it to control a lathe. I
skimmed through the manual and found no mention of G76. Do you know
if it will support G70/G71? I was told that machIII wouldnt. I think
that being able to digitize and use the tool length presetter are big
bonuses for DeskCNC.
William
website and found no mention of using it to control a lathe. I
skimmed through the manual and found no mention of G76. Do you know
if it will support G70/G71? I was told that machIII wouldnt. I think
that being able to digitize and use the tool length presetter are big
bonuses for DeskCNC.
William
Discussion Thread
Will
2005-02-21 08:21:39 UTC
Mach III and DeskCNC
Fred Smith
2005-02-21 12:02:14 UTC
Re: Mach III and DeskCNC
John Stevenson
2005-02-21 15:09:09 UTC
Re: Mach III and DeskCNC
Will
2005-02-21 18:06:32 UTC
Re: Mach III and DeskCNC
Will
2005-02-25 15:46:38 UTC
Re: Mach III and DeskCNC
ballendo
2005-02-27 07:46:32 UTC
Re: Mach III and DeskCNC
John Stevenson
2005-02-27 08:02:48 UTC
Re: Mach III and DeskCNC
Will
2005-02-27 08:41:55 UTC
Re: Mach III and DeskCNC
John Stevenson
2005-02-27 09:04:24 UTC
Re: Mach III and DeskCNC