Re: [CAD_CAM_EDM_DRO] Re: Question about steppers
Posted by
Alan Marconett
on 2005-03-02 12:04:00 UTC
Hi Dave,
I agree, probably even better to use two drivers, and just do digital
switching on the step/dir lines.
Alan KM6VV
turbulatordude wrote:
I agree, probably even better to use two drivers, and just do digital
switching on the step/dir lines.
Alan KM6VV
turbulatordude wrote:
>
> There is a caution about switching motors.
>
> It is best done manually or automated with caution.
>
> First remove power from it. then switch leads, then re-apply power
>
> Don't use relays as if one contact fails, poof, there goes the
> driver. That is unless you use the Gecko Vampire.
>
> Dave
>
Discussion Thread
Will
2005-03-01 14:05:48 UTC
Question about steppers
R Rogers
2005-03-01 14:52:07 UTC
Re: [CAD_CAM_EDM_DRO] Question about steppers
cnc_4_me
2005-03-01 16:41:00 UTC
Re: Question about steppers
Will
2005-03-01 18:20:30 UTC
Re: Question about steppers
turbulatordude
2005-03-02 05:34:29 UTC
Re: Question about steppers
Bruce Pigeon
2005-03-02 08:23:30 UTC
Re: [CAD_CAM_EDM_DRO] Re: Question about steppers
Will
2005-03-02 09:19:36 UTC
Re: Question about steppers
Stephen Wille Padnos
2005-03-02 09:46:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Question about steppers
turbulatordude
2005-03-02 09:49:24 UTC
Re: Question about steppers
Will
2005-03-02 11:36:53 UTC
Re: Question about steppers
Alan Marconett
2005-03-02 12:04:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Question about steppers
Stephen Wille Padnos
2005-03-02 12:07:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Question about steppers
turbulatordude
2005-03-02 12:54:51 UTC
Re: Question about steppers
R Rogers
2005-03-02 16:15:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: Question about steppers