Re: [CAD_CAM_EDM_DRO] Wire size question...
Posted by
JanRwl@A...
on 2005-04-07 14:05:30 UTC
In a message dated 4/7/2005 6:08:46 A.M. Central Daylight Time,
jeff@... writes:
Why would you feel hesitant about using it on a free air application (which
normally allows you to drop to a smaller wire size
Jeff: Not because of practical rules and safety considerations, but
because I simply had the feeling the person asking the question wanted to avoid
voltage-drop in his lines, even though they WERE only one foot (300 mm). Oh, if
I had to do that and only had some #12 stranded on hand, I'd use it, even
for a contract job. I guess I'm just over-conservative when designing.
[Non-text portions of this message have been removed]
jeff@... writes:
Why would you feel hesitant about using it on a free air application (which
normally allows you to drop to a smaller wire size
Jeff: Not because of practical rules and safety considerations, but
because I simply had the feeling the person asking the question wanted to avoid
voltage-drop in his lines, even though they WERE only one foot (300 mm). Oh, if
I had to do that and only had some #12 stranded on hand, I'd use it, even
for a contract job. I guess I'm just over-conservative when designing.
[Non-text portions of this message have been removed]
Discussion Thread
loudcouture2003
2005-04-06 17:54:50 UTC
Wire size question...
Jeff Goldberg
2005-04-06 18:26:11 UTC
RE: [CAD_CAM_EDM_DRO] Wire size question...
turbulatordude
2005-04-06 18:52:03 UTC
Re: Wire size question...
John Rouche
2005-04-06 19:57:12 UTC
Re: Wire size question...
Jeff Goldberg
2005-04-06 20:17:31 UTC
RE: [CAD_CAM_EDM_DRO] Re: Wire size question...
Jeff Goldberg
2005-04-06 20:20:12 UTC
RE: [CAD_CAM_EDM_DRO] Re: Wire size question...
JanRwl@A...
2005-04-06 20:59:20 UTC
Re: [CAD_CAM_EDM_DRO] Wire size question...
loudcouture2003
2005-04-07 00:46:48 UTC
Re: Wire size question...
Jeff Goldberg
2005-04-07 04:07:42 UTC
RE: [CAD_CAM_EDM_DRO] Wire size question...
John Rouche
2005-04-07 06:30:20 UTC
Re: Wire size question...
Roy J. Tellason
2005-04-07 08:59:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: Wire size question...
JanRwl@A...
2005-04-07 14:05:30 UTC
Re: [CAD_CAM_EDM_DRO] Wire size question...