CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: E-stop Problem + more

Posted by Ray Henry
on 2000-06-09 10:27:36 UTC
>Message: 16
> Date: Fri, 09 Jun 2000 05:05:36 -0000
> From: imranjawaid@...
>Subject: Re: E-stop Problem + more
>
<snip>
>
>I tried to short pin 13 with 19 (GND) on my only parallel port ,
>changed the ini file aux_io port to 378 . but no luck.
>
>I tried Ray procedure (which is to change EMCIO to minimillio in
>emc.ini)& got out of Estop only in steppermod.o file.
>But i'm using the stg2mod.o file (STG 2 card). /w AC Servo. The
>minimillio file didn't workout for the STG2 card.
>
>I prefer the ini file editing prcedure as i'm not good in electronics
>or Linux.

I'm not very well versed here but I think that once you switch to the stg
definitions in the ini file then you have to use the stg pins to do the
work. I know that I've seen a document that lists all of the pins on the
stg and what signal they hold for emc but I don't know where it is.

Ray

Discussion Thread

imranjawaid@e... 2000-06-04 22:35:44 UTC E-stop Problem + more Tim Goldstein 2000-06-05 06:43:41 UTC RE: [CAD_CAM_EDM_DRO] E-stop Problem + more Jon Elson 2000-06-05 12:44:00 UTC Re: [CAD_CAM_EDM_DRO] E-stop Problem + more Ray Henry 2000-06-06 09:46:47 UTC Re: Re: E-stop Problem + more byron@w... 2000-06-06 18:01:10 UTC Re: [CAD_CAM_EDM_DRO] E-stop Problem + more imranjawaid@e... 2000-06-08 22:05:40 UTC Re: E-stop Problem + more Ray Henry 2000-06-09 10:27:36 UTC Re: Re: E-stop Problem + more imranjawaid@e... 2000-06-10 06:48:13 UTC Re: E-stop Problem + more Ray Henry 2000-06-13 15:57:38 UTC Re: Re: E-stop Problem + more